what is the correct cutting formula for a delta loop, apex up, fed one quarter wave from apex?
what is the correct cutting formula for a delta loop, apex up, fed one quarter wave from apex?
I thought the formula 1005/freq in mhz applied to delta loops too, for measurements in feet. I would need to go look again...
Like that post was...
Moving on, my posts are not helpful
Check out the "right angle delta" on this page:
SCVs: A Family Album (antentop.org)
Most of the time we are punished if we go against the trend. Only at an inflection point are we rewarded. ~ George Soros
Thanks TKX!
Very helpful.
Kirk K9WW