Activity Stream

Easy to swap the added port for an 8.83MHz output and hook a panadapter/SDR to it then.

Correct, it does not come from the factory that way.

I have a couple of those. Your comments made me look up the manual, as I don't recall any IF Out connections on their rear panels. (There aren't from...

AAAAAAAAAAAAAAArhg!

Good Morning and thank you. I'll save my money then and use it for something that I will probably use more daily or use when I go on trips with the...

The 455KHz IF Out was meant to be coupled to a scope to look at post-filter IF signals. Modulation envelopes, things like that. Some of the rigs...

*aye ... groan*

OK so, I don't know enough about this (utilizing an IF output) but the FT710 is a stand alone SDR, as per everything Yaesu says. I believe the IC7300...

Don’t know much about the FT710 so I hesitate to venture advice. I think that it’s intended to drive black box hardware SDR computer interface units.

OK, I'm listening. Could I plug it into the antenna port on my FT710?

I dunno, Ash, what can you do with a 455kHz IF ouput? Seriously, you can use it as input to an SDR reciever.

I've never had a good time with vz when it comes to their stupid gear. I never used their router so when they started charging me for it I told them...

Feed a remote tuning arrangement? Like for a transverter?

Yep, it does have an AC cord.

My employer uses W11 Enterprise in the LTSC license. As does my wife's. I've tweaked her personal laptop's W11 Pro installation to be as free of M$...